Recent content by 65electra

I have a 65 Electra and cannot tell where to check and put the hydraulic fluid for the motor. I have the backseat out and can see the motor but I'm not sure where to check , thank you in advance

Can I by pass everything and run New wires to get car to start . I've tried everything , running jumper wires (which burned up) etc etc . From switch to battery to coil , stuff like that

I was getting no spark to my coil . So I ran a jumper wire from the battery to the resistor on the 12 volt side . Can I leave the jumper wire there or do I need to keep looking for my problem . Thank you in advance for any help

I am at wits end . My electra with the 401cid nailhead was not getting any spark to the coil . I ran a jumper wire to the resistor on the 12 volt side from the battery , can I leave that wire there or do I need to keep looking for problem . Thank you in advance for any help

I have a 65 buick electra convertable with a nail head 401. Was not getting a spark to the coil . Ran a jumper wire to the resistor (12 volt side) to the battery car started right up . Can I leave that wire there or do I need to look for other problem . Thank you in advance for your help ,