Recent content by JSBuzz

Rebuilding my 350. Called TA performance and they told me I could open up the core line from the screen to the oil pump to 9/16. Right now the line is 7/16 and the recommendation I have seen up till now have all been 1/2. Don't want to screw-up a good block will dive into the recommended...

Thanks for the help

I am rebuilding a 350 small block. I understand there are modifications that are recommended to be made to the lubrication system. Does anyone have what the recommendations are for the buck 350?

Todd, I can't thank you enough. That is awesome information

Thanks, my guess is Rock Auto a the like are selling the wrong parts.

Thanks

Thanks but the car has a 4 speed mincie. Those flex plates are for automatics. I just need the ring gear. Any idea we're I can get just a 160 tooth ring gear?

Hi i have a 1970 buick skylark with a 350. The ring gear on the flywheel has 160 teeth. All the on line ring gears i can find for this car are 153 teeth. Has anyone run into this issue? Does anyone have any idea where i can get the correct ring gear to fit a manual trans flywheel for a 350

Bob thanks, attached is what I found. Hope it can be read

I have a 1970 skylark custom. Found the build record under the back seat. Does anyone know where to find a description of what these codes mean?

Doing a brake job on my 70 skylark and made the bad mistake of getting the disc's from auto zone. The were manufactured by Duralast. The quality wasn't good. Can anyone recommend a manufacturer that makes a quality product?

Hi I am new to the forum. I have a 1970 skylark. The engine serial number does not match the vin so I believe the block is not original. The engine code is not like anything I have seen on line. The info fro the block is engine block serial number -40107178 engine casting number - 1382201...