1- Can stock rods be bushed to accept a .93 or .92 diameter piston pin?
2- Or conversely, can the piston pin end be bored to accept a .98 diameter pin? Or should I ask what diameter can a stock rod piston end be bored to?
3- Is this a process an average machine shop can do?
thanx in advance!
2- Or conversely, can the piston pin end be bored to accept a .98 diameter pin? Or should I ask what diameter can a stock rod piston end be bored to?
3- Is this a process an average machine shop can do?
thanx in advance!
Last edited: