Search results

My one is a little bit more than slightly ,worn out..., especially in the end where it sits in the carrier. Have seen this while I'm fix my Wheel Seals and Bearings .. Measurements are 0,75" Inch in dia. and 5.5" in lengths. Had looked for adequate shafts from other Car brands on Rockauto and...

I had try to let sleeved my mc,but the machining shops told me, it isn't possible at this part.They can overbored it and build a new Piston for it. That wasn't ok for me. The Remanufactured mc ,I heard not so good thinks about it... After search arround i found the Mc 2796 from a CJ 6 Jeep, it...

The motor is pimped with much more compression , overbored to near 290 cui. with 84mm BMW pistons, bigger Valves (Deutz) with smaler 8mm stems, sharper cam and 3 kilo lighter Flywheel ( made for dynaflow crank ) with 4 Ltr. Cherokee clutch. Deck is 2 mm milled and the ported Head also all is...

Hi Guys, Ive got an offer for Gearbox what Im lookin for , the Cast # on my Box is 1301637-4, the offered Box is the same instead of the last -4 is there a -2. Anybody can tell me the different ? Its only from another Plant i think,thats right ...

Hi Guys, Im looking for a completly '55 Roadmaster Coupe Dynaflow rear Axle. A new Customer of my Garage,where i do work, drove the Axle to long without oil,all is run Dry and its damaged !! :angry: !! Now I'm look for him for a Spare One .

I had just read the other Topic for the right height of a `52. I wanna lower my `38 (since Years) for nearly 2",by ONLY other Springs. I know from the Fatman 2,5"dropped Spindles,but it's not a Option for me. Have Anybody an Idea or experience for what for OEM Springs from another Make/Model...

In the Moment is Winter Time thats mean its Time for Service. I jacked up the Car,getting off the Wheels for Brakeservice last Week. Now I can show you my modification, from 2 Years ago,of the front Shocks.

WANTED: '38 Special Gearbox (I can't open the classified Thread,thats wy i do it here) I'm look out for a original complete Box,in any condition,its for spare if somthing in the Future will broken and i need it then directly. Feel free to make a Offer and contact me ,if you have one or you...

Hi together, Im search for this Size of Plugs for a 263er. Is anybody know where they are also in the Engines? (Mopar,Ford,GM or so..) I can here order only complete Sets without whats Size inside. I know that Bobs Automobilia,or Oldbuickparts have it,but its need so much time for Shipping...

Hi Everybody (its so quiet here..) My Crank is at the moment to balancing and the Guy told me that the original Damper is not so good. Have anybody of you replaced the old one for a better one ,Fluiddamper SBC, or something like that ? Any Ideas ? Or have we here an older Post about this...

Hi Guys, My Engine leaks horrible at the rear, now I will seal up my Rearmainbearing with a set of rubberseals from Bestgasket No. 3764, or a set of a sealing-rope No.5143 Can everybody tell me how it works? what must i machining for it? Or any other Idear? Thanks ahead Jenz