I am trying to get a 364 and dynaflow back into service after a rebuild. Removal was 4 years ago and I need help with Throttle linkage and the stator linkage back to Dynaflo. Where does this part bolt into? Engine and Transmission are already back in car. Any help would be greatly appreciated.
Thank you both so much. That is it! Could it be bolted to eng/trans with bell housing bolts?? I am going to have to raise the car to get a better look at this area.
The layout of those bolt holes on the bracket looks kind of funny, like the holes are meant to fit on a round pattern. The bell hsg holes above the starter bulge look like they might match the bracket. See attached front view of the bell housing.
Thanks for all help. Exactly where you suggested. Raised the car and installed this AM. I highly recommend putting this on before the engine and transmission are bolted into the car! I am trying to put everything together for a test run of freshly rebuilt engine and a transmission overhaul.