"Buick Trademark(s) used with the written permission of General Motors"
 
 
Home Forums Garage Classifieds Reference

Bolt in Drive Shaft Loop

I have seen these manufactured somewhere, but couldn't find one when I wanted it. There could be a reason for the lack of availability, perhaps they are not recognized for drag racing events or ? Perhaps someone will tell us. I liked the look of them because you didn't have to drill your floor supports to install, making them great for classic cars and adding some degree of safety when you decide to "walk on it"!

  • 1/2"X2" flat bar - 3"
  • 1/4"X2" flat bar - 14 1/2"
  • 5" ID pipe - 2"
  • 2 bolts 1/2" longer than currently used in your transmission mount.
Bolt hole spacing is 1 1/2" for Muncie. A picture is about all that is needed for instructions: