"Buick Trademark(s) used with the written permission of General Motors"
This manual is offered free on the site for your use. You may download sections or print pages. Please do not modify any pages or remove any references to this site.
This manual contains chassis service information for all 1968 Buick Models. Refer to the Introduction for a description of the arrangement of this manual. This will enable you to locate desired information easily.
All information, literature are based on the latest product information available at the time of publication approval. The right is reserved to make changes at any time without notice.
|
TABLE OF CONTENTS
|
||
|
GROUP
NO. |
SUBJECT
|
PAGE NO.
|
|
0
|
GENERAL INFORMATION, MAINTENANCE, AND LUBRICATION
|
|
|
1
|
WINDSHIELD WIPERS
|
|
|
HEATER SYSTEM
|
||
|
HEATER - AIR CONDITIONER SYSTEM
|
||
|
2
|
FRAME AND BODY MOUNTINGS
|
|
|
3
|
FRONT SUSPENSION AND FRONT END ALIGNMENT
|
|
|
4
|
REAR SUSPENSION, PROPELLER SHAFT AND DIFFERENTIAL
|
|
|
5
|
BRAKES
|
|
|
6
|
ENGINE MECHANICAL
|
|
|
ENGINE FUEL SYTEM, FUEL PUMPS AND CARBURETORS
|
||
|
CRUISE MASTER
|
||
|
CONTROLLED COMBUSTION SYSTEM
|
||
|
ENGINE ELECTRICAL-GENERATING, STARTING AND IGNITION SYSTEMS
|
||
|
ENGINE TUNE-UP
|
||
|
7
|
CLUTCH
|
|
|
MANUAL TRANSMISSION
|
||
|
SHIFT LINKAGE
|
||
|
SUPER TURBINE 300 TRANSMISSION AND SUPER TURBINE 400 TRANSMISSION
|
||
|
8
|
FUEL TANK AND EXHAUST
|
|
|
9
|
STEERING
|
|
|
10
|
WHEELS AND TIRES
|
|
|
11
|
CHASSIS SHEET METAL
|
|
|
12
|
CHASSIS ELECTRICAL AND INSTRUMENT PANEL
|
|
|
13
|
RADIATOR AND GRILLE
|
|
|
14
|
BUMPERS
|
|
|
15
|
ACCESSORIES
|
|
|
|
ALPHABETICAL INDEX
|
|
The service information included in a SECTION is divided into four basic DIVISIONS. The titles of each DIVISION are:
| Division | Area |
| I | Specifications and Adjustments |
| II | Description and Operation |
| III | Service Procedures |
| IV | Trouble Diagnosis |
A DIVISION contains one or more PARAGRAPHS which can be identified by the series of numbers preceding them. The PARAGRAPH number consists of the GROUP number, a hyphen, and a sequence number; paragraph arrangement is numerical.
SUB-PARAGRAPHS are used when necessary for clarity or to provide distinction between component procedures. SUB-PARAGRAPHS are designated by a letter and are in alphabetical order.
SPECIAL TOOLSReferences are made throughout the manual to special tool numbers, designated by the prefix letter "J". These tools are manufactured by the Kent-Moore Organization, Inc. If equivalent special tools are not available locally, they may be obtained through:
| Kent Moore Organization, Inc. 28635 Mound Rd. Warren, Michigan 48092 |
To locate any desired information, locate the proper GROUP listed on the front page of the manual. Bend the manual until the black tab on the first page of the GROUP can be seen in line with the GROUP title on the front page. The first page of the GROUP lists the SECTIONS contained herein. Turn to the proper SECTION, locate the desired DIVISION, and note the page number of the PARAGRAPH containing the information you are seeking.