iddie makel
Active Member
Hello everyone,
I think I may have installed my rocker shafts incorrectly . I pulled my valve covers & little or no oil is seeping from the rocker arms.There is oil on the head & I do have oil pressure.The push rods are mostly dry except for assembly lube.On one side of the shaft there are 4 holes for the mounting bolts.On the other side in addition to the mounting bolt holes there are smaller holes for the passage of oil.I can't find a pic in my shop manual or chilton's manual.
Does anyone know which side of the shaft should be in the up position? I installed the shafts with the sides with the most holes in the down position.This is a V-8 264 engine.As always,I am thanking you in advance for your responses.
iddie
I think I may have installed my rocker shafts incorrectly . I pulled my valve covers & little or no oil is seeping from the rocker arms.There is oil on the head & I do have oil pressure.The push rods are mostly dry except for assembly lube.On one side of the shaft there are 4 holes for the mounting bolts.On the other side in addition to the mounting bolt holes there are smaller holes for the passage of oil.I can't find a pic in my shop manual or chilton's manual.
Does anyone know which side of the shaft should be in the up position? I installed the shafts with the sides with the most holes in the down position.This is a V-8 264 engine.As always,I am thanking you in advance for your responses.
iddie