Recent content by GL03

Is this your electric circuit? I found it in the Library on this site and located in the home page. In this circuit, when the ignition switch is in ignition 1(yellow wire) it goes through the resistor, but in ignition 2(black wire), which is where the car will run, it does not. It is bypassing...

It took me three visits to go through all the aisles. If we can get interested count in this thread, TeamBuick members could all meet at Pomona one meet.

when the vehicles are tested, wind noise, heat and water ingress is some of many things they aim to eliminate because they negatively impact the driver or the performance of the vehicle. The workshop manual is an amazing source of information I read it every night before going to bed.

Try buickfarm.com

Pomona Swap Meet | Event Hours & Dates| Pomona Swap Meet

I want to add a booster like you have because it angles the setup to clear the chassis. Then I won't need to cut or reinforce the chassis for the mod.

I've been browsing around and it looks like I have a late reproduction letter. The indicator is that there is no numbers or letters to identify and that at the base of the studs it becomes a square in respect to my letter that does not. But, aside from that it absolutely will not work on my...

I purchased a letter "I" on ebay with excellent chrome. I was too lazy to measure my old letter on my 63 skylark because it looked so alike. I receive it and the mounting studs are 1/2 " seperation center to center. My "I" on the hood of the skylark are 5/8" separation center to center. Another...

Attaching link for conversion youtuber created.

I think we should move "Reference" along with "Library" to top of list with larger Red font. And or add some fairy magic so it can be found. Bob, you working extra.

I used to have an intermittent stalling from my 63 vehicle with 4GC, shifter on column, and AUTOMATIC dual path transmission. It occurred in all kinds of nerving situations: intersection, making a turn, freeway, etc. The nipple on the neutral switch broken off made it possible to turn the car on...

is it possible to see some more pics? i noticed you have a red tether for the hood and can't quite see it along with the engine bay.

my filter on dual path had metal mesh, I cleaned it with spray, if the new filter dont look right it probably isnt. WD40 will soften hardened rubber. Synthetic silicone paste on rubber or dielectric grease could be used to refit a hard connection, let it sit overnight so the chemicals do their...

Petronix system you have to set the gap from the trigger to the distributor lobe at installation. Since your shop did install i would check to see it is secure and properly fitted.

The problems occurred after the shop put hands in it. Good quantity of auto shops are parts changers with no clue how cars work and could care less? A testdrive is would be part of this type service visit. They shouldve caught that before delivery.