I have sprayed around the carb area with starting fluid without result. throttle shafts are nice in the bores. not loose. I have been up and down with the timing both with the vacuum connected and blocked to know that I'm not going to solve the problem with timing. At this point I am thinking I...
I have played around with the timing, mostly with the vacuum advance disconnected. No help. I think right now the timing is at about 0 degrees with vacuum disconnected. The vacuum advance does work and does not leak. I should also mention that the crankshaft dampener has been checked for correct...
I bought a rotted out but running and driving 66 wildcat for parts for my project. This was a 401, didn't run great but was able to cruise with it a bit. car idled ok. When I brought the engine in for rebuilding the block was bad. Found a 425 block and did a complete rebuild to stock. Used the...
I would like to replace the oring for the filler neck on my 66 wildcat fuel tank. I have not been able to find either the oring or a part #. Can anyone help?
I could be wrong, but the "nailhead parts interchange" shows the interchange between the 364 and the 401-425, not necessarily between the 401 and 425, right?
Will the top end parts from a '66 401 fit on a 425? I mean heads, intake, exhaust manifolds. I'm fairly new to the nailhead world, but it seems the 425 is basically large-bore 401, right?