Search results

  1. A

    Distributor ID help

    Hello, can anyone help me decode the distributor I have? A few of the numbers are difficult to distinquish so I'll write what I think they are. Thanks very much. Tony in Idaho 1112985-5N3 or 1112935-5N3
  2. A

    edelbrock float adjustment

    I installed a TA manifold and edelbrock 600cfm on my 350 last weekend. Runs well but has to crank for 5-8 seconds to fire once warmed up, then shut off. Starts very quickly when cold so my thought is the floats are to high. Any thoughts on this annoying problem with a new carb? Engine...
  3. A

    4 V Manifold for 350

    Hello, would a original cast iron 4v intake fit on a 350 originally with a 2 barrell? What intake gaskets? Otherwise, if I were to buy the TA intake which intake gaskets should be used? Thanks Tony 1969 skylark 350
  4. A

    Where to buy a heat riser valve?

    Hello, my exhaust heat riser valve is broken/cracked and I can't seem to find another. Anyone know where I could find a new or decent used one? 1969 Skylark 350 Thanks Tony
    • abranz
    • Thread
    • Replies: 0
    • Forum: 350
  5. A

    1969 skylark progress

    Well, I am slowly making headway but every step is slowed by rust or other problems. I can't seem to get the sway bar links back in. My thought is because the car is on jacks. I do have the glass and door panels back in. Also the engine/trans/rear diff are back in. I've got some more rust repair...
  6. A

    motor mount question

    I'm getting ready to plant the rebuilt 350 and forgot which way the engine mounts go on the engine. I know they'll only work one way but would like to get them mounted right the first time. Sorry such a dumb question. Tony
    • abranz
    • Thread
    • Replies: 1
    • Forum: 350
  7. A

    Where to find 350 valve covers?

    Hello, my 69 350 valve covers are shot. I've looked in the classifieds but cannot find any. Anyone know where I could find a set? Thanks Tony
    • abranz
    • Thread
    • Replies: 3
    • Forum: 350
  8. A

    69 skylark heater control

    Anyone know where I can find a interior heater control unit for my car? The cable bracket broke off the plastic housing. Thanks Tony
  9. A

    Suspension spring R&R?

    Well, I've finished the body work on my 69 Skylark and now am focussing on the mechanical. How should I go about replacing the springs without self injury? Thanks, Tony
  10. A

    How to remove rear seat?

    Hello, first post here and I'm somewhat embarrased but how do I remove the rear seat on a 69 skylark? Thanks, Tony
  11. A

    350 4barrel intake?

    Hello, I'm new to buicks and am beginning a restoration of my grandfathers 69 Buick coupe with a 350. Did any of the 350's come with a four barrel carb/intake and if so which carb was used, a Q-jet/ Thanks, Tony
  12. A

    Hello, new member in Idaho

    Hello, just joined as I'm beginning a restoration of my grandfathers 69 Skylark. It's complete with only 75000 miles but has rust through on the bottoms of the front and rear quarter panels and the battery tray. I've searched for patch panels without luck. Does anyone know where I could find...
Back
Top