Search results

I've got a '93 LeSabre that runs great, even with 250k miles, with an annoying problem. It sometimes stalls when you let off the gas i.e. when turning or stopping. Seems to lessen when the tank is full. No codes show and the car accelerates and drives just fine. New plugs and wires 4 or 5k ago.

Skylark colors Plate is damaged, looks like it was white w/red interior. We want to know what else was avalable. Thanks

I'm helping a friend on a '53 Skylark, and we need to know what colors they came in. It was purchased after complete blasting, no sign of the original color and no upolstery. What color interior and trunk lining were used? I found a notation in "70 years of Buick" that sounds like the wheelwells...

To start, I know I can't use E85 in my Buick. What I want to know is what mechanical problems ethanol, in any concentration, could cause in any gasoline engine. Also, how much gas milage loss could I see using different concentrations. It looks like I am losing about 6% in my '02 LeSabre with...

How do I get the unlock codes for my radio? The dealer tells me I have to bring the car in and have them pull the radio to get the numbers off of it then they will contact G.M. and get the codes. Sounds like B.S. to me. If I replace the battery or it goes dead, I should pull the radio to get the...

Is there a website that I can get a factory build sheet for the '02 that I just bought? I want to know what options it was originally equiped with. It's a Limited.-Thanks

I have a three speed from a 58 Special wagon, you can have it for $100 plus shipping.-JRL

Why do most mechanics advise me to stay away from the supercharged 3.8? They don't say why. What do I have to watch out for?

My 93 LeSabre will not accelerate from a part throttle position. When driving at any speed, if I step down normaly(not passing gear),it will hesitate and bog down. If I let the gas pedal back to idle then step down(again not passing gear) it will accelerate normaly.I still get an intermitant...

I have an intermitent check engine lite that reads code 43. The lite comes on mostly at idle or low engine load. It is not when the knock sensor should be reading anything. I erase the code and it may stay gone for a month or a week or a day. All tests show no problem. What's my problem?

I have a broken wire on the ign switch that reads the key chip to overide the security device. Can it be repaired?

Hi- I'm looking for the balance specs for a 425 manual trans flywheel, the one that the factory uses when they are manufactured. I have a flywheel that will fit the crank but it has to be balanced. I don't want to take apart the motor if I can help it. The only car that came with a 425 and stick...