Search results

What size are the bolts in the rear mount to bellhousing? I know it's 12 tpi but 1/2" & 9/16" are this pitch. I reckon it has to be 9/16" as a 1/2" bolt has sideways slop. Could someone stick a wrench on the head and tell me for sure? Art

Hi, After 20 years apart I'm re-assembling the headlamps on my '38 and I (of course) can't remeber what goes where.:clonk: I have two lenses numbered 920946 & 920947. The reflectors are also slightly different in that one has two horizontal creases in the upper half and the other has a little...

Can anyone out there tell me how to adjust the big end clearance on a 1938 series 90 engine. These are the babbit style bearings with shims. How can I tell if I have the correct clearance. I have the pistons out to replace the rings. I've seen something about leaving out one of the rings. Which...

Hi All, I asked if anyone knew where to get the seal at the gearbox end of the torque tube and got no feedback. It's the ball shaped housing and it has a big circlip inside so I assumed it's there to hold a seal. Is this a good assumption?? The car is a 1938 model 90. Regards Art

Newbie here, Is there a supllier for the seal on the ball at the gearbox end of the torque tube. Thanks 38 Limo