iddie makel
Active Member
Hello everyone,
I finally got most of my freeze plugs in,and also got the pilot bearing replaced.I have not replaced the four large freeze plugs yet on the sides of my block because there is all kinds of rusty looking dirt and material inside.I hate to be doing my first rebuild and then seal all this stuff in there.Apparently the rebuilder/machine shop did not boil out the block.when you guys get some time,would you give me some thoughts as to what you would do.is it possible for me to just flush this stuff out without messing up my new engine parts?I would think that if I leave it in there it's going to circulate around and clog up everything.thanks in advance.
iddie
I finally got most of my freeze plugs in,and also got the pilot bearing replaced.I have not replaced the four large freeze plugs yet on the sides of my block because there is all kinds of rusty looking dirt and material inside.I hate to be doing my first rebuild and then seal all this stuff in there.Apparently the rebuilder/machine shop did not boil out the block.when you guys get some time,would you give me some thoughts as to what you would do.is it possible for me to just flush this stuff out without messing up my new engine parts?I would think that if I leave it in there it's going to circulate around and clog up everything.thanks in advance.
iddie